€ 31.50 · 4.9 (495) · In Magazzino
My son was using his Elegoo kit I got him. He had done lesson 3 (hardwire an LED), and was doing lesson 4 and could not get it to work. I then plugged in my Arduino Uno R3 to see if it was the Arduino. Same result. So I got out my volt meter, and I'm only getting a few millivolts between the V5 pin and GND. It's possible something was wrong with his circuit that fried the regulator on his board, and then when I plugged mine it it fried mine also? Anyway, I should always get +5 out of the
Uno - Using 5v and 3.3v pins at the same time? - General Electronics - Arduino Forum
ATmega328P UNO R3 Development Board Improved Version Enhanced SCM Yellow Module
Actuating A 5V Push/Pull Solenoid - Motors, Mechanics, Power and CNC - Arduino Forum
Arduino uno +5V/GND pins question - IDE 1.x - Arduino Forum
Arduino Uno R3 before disaster? - Project Guidance - Arduino Forum
Prevent/ eliminate noise/interference in project - General Electronics - Arduino Forum
Fried my Uno board - General Electronics - Arduino Forum
Why don't Arduinos run on 5V - Project Guidance - Arduino Forum
How to power motor shield - Project Guidance - Arduino Forum
How to power Motor and Arduino with single power source - Motors, Mechanics, Power and CNC - Arduino Forum
Tangxi 3D Printer CNC Kit with CNC Shield V3.0&A4988 Stepper Motor Driver for UNO for R3 Board&Heatsink&Nema 17 Stepper Motor&USB Cable, CNC Kit for Kuman for UNO for R3 : Industrial
Stepper motors not responding - Motors, Mechanics, Power and CNC - Arduino Forum
No 5V+ from Arduino Uno R3 - Motors, Mechanics, Power and CNC - Arduino Forum